TSC Installation Instructions

  • NEW! Make sure ignition is turned off for at least 10 minutes before installing.
  • Locate accelerator pedal electrical connector and disconnect.
  • Plug corresponding connectors into respective plugs.
  • Tie wrap the cables out of the way.
  • Determine a good location for TSC Controller placement where it will be easily accessible.
  • Mount using the supplied 3M Velcro 2 sided tape
  • Turn on ignition the Power Level LEDs will be in pre calibration mode (chasing)
    VERY IMPORTANT PART READ CAREFULLY AND UNDERSTAND BEFORE PROCEEDING
    PUSH AND HOLD BOTH THE UP AND DOWN BUTTONS BEFORE PRESSING ON THE ACCELERATOR PEDAL THEN WHILE BUTTONS ARE PRESSED PUSH THE ACCELERATOR TO THE FLOOR
    RELEASE THE 2 BUTTONS WHILE THE ACCELERATOR IS STILL TO THE FLOOR
    AFTER YOU RELEASE THE BUTTONS YOU CAN REMOVE YOUR FOOT FROM THE PEDAL
  • Only the first LED should be illuminated at this time.
  • Start vehicle, and you are done
    • FIND A DISTRIBUTOR

    Contact Us

    If you have any questions, please don't hesitate to get in touch.

    Chat

    Click to chat now.

    Email

    info@v-p-p.ca