Likely, please take a look at our supported list. If your vehicle is not listed there, please (CONTACT US) and we will verify if we can operate with your vehicle

Maybe, please check out our application list here. We recommend returning it to stock before moving it to protect the new vehicle. Do this by pressing both buttons on the device at the same time and the lights will start to "chase" again. The device is then ready to be installed on a new vehicle.

Yes, press both buttons on the device at the same time and the lights will start to "chase" again. The device is then ready to be installed on a new vehicle.

Since our device does not actually modify the ECM and only adjusts the throttle curve within manufacturers tolerances, there is no added wear and wear over your vehicle's stock settings directly from the factory.

NO! Our device makes no changes to your vehicle emissions and because of this to our knowledge does not violate any emissions laws in North American.

No! after the initial calibration the device will automatically turn on/off in the same state it last was in! Keep in mind, some vehicles will keep the ECM and related systems powered on for up to 10 minutes after turning the key off. Therefor our device will not turn off until the related systems are also offline.

Yes! But the use of these other products are at the users' own risk and will void your warranty if you are not careful. Our device will still operate alongside it if you choose to use one.

This is usually caused by the ECM system still being powered on when you unplugged your pedal, clear the codes and it should not come back on. You can clear the codes by unplugging your battery for 15-20 min or using a scan tool. We recommend disconnecting the battery from the vehicle before installation to ensure this does not happen.

This can only really be caused by two things: (1) The connectors were not plugged in firmly after installation and a connection is intermittent, or (2) the vehicle was not let sit long enough for the ECM to enter quiet mode (depending on vehicle 5 - 10 mins).

We offer a 12-month warranty with proof of purchase and after some remote troubleshooting. Please contact us and we can work through it with you :)

Please run the calibration routine again, this can be a problem if the device was not reset between vehicles as well.